How to join two surfaces

@Simonsen89 wrote:

Hi

I'm new to Rhino, and I'm facing a problem with joining two surfaces. One surface is made with the surface "Loft" feature, whereas the other is made with "Surface from network of curves". The two are created with the same curve at the interface.

When I try to join the two, I get an error stating:
"Edges are too far apart to merge"

I've attached my project, if any of you want to give it a try. The project has three surfaces, where only the "curved" surface is made with "Surface from network of curves". The plan is to join all three, but I can't even join any two of them.

Surfaces.3dm (117.4 KB)

Thanks in advance

Best regards Anders

Posts: 4

Participants: 2

Read full topic