@nsgma wrote:
Hello,
I have seen this discussed dating a few years back.
When I do a parallel view and then in layout I set the scale to say 1:1 I would expect that a cube of 100 x 100 X 100 show the side of the cube to be 100 mm, instead it comes 81.649658 mm.
The only advantage (and don't use it much) of an isometric is to be a 3D illustration, which is also measurable. If it is not it beats the purpose.
Any ideas?
N
PS. by the way I was just about issuing a series of contractual drawings with scaled isometric drawings.
Posts: 6
Participants: 3