Creating 3D surface from cross sectional curves

@jasmine8 wrote:

Hi guys!
I'm pretty new to Rhinoceros, and is running into the problem of using Loft command.
The objective of my project is to use 2D cross sectional curves to reconstruct the 3D surface model. The above problem arose because I have two curves in same elevation.
When I use Loft, Rhino creates surfaces that fills inside the gaps between the curves within same elevation. I also have this very ugly crease at the bottom which I don't know how to resolve.
Please help me troubleshoot these problems. In advance, I appreciate any help and tips on how to create such model! Thanks!
-Jasmine

Here is the link to the screenshots I took.

Posts: 7

Participants: 2

Read full topic